FLASHING ROCKCHIP RKXXXX TABLETS

FLASH YOUR ROCKCHIP TABLET LIKE POLAROID, TOUCHMATE USING ROCKCHIP BATCH TOOL!

Again before Flashing make sure you have tried other alternatives such as Recovery Mode and RK29XX Wipe All. Before flashing, backup your Dump Rom First if your Tablet's USB Debugging is Enabled.

Step by Step Rockchip Tablet Flashing Tutorial

1. Charge your Tablet. It must be full charged or not Low Battery.

2. Download your Firmware / Rom corresponding to your Tablet's Model at the Rockchip Rom Section.

3. Download Rockchip Batch Tool (with drivers) by clicking here

4. Extract Files to any destination folder (ex. desktop)

4. Open Device Manager. Choose one to access Device Manager

a. Press Winkey, type Device Manager then click Device Manager

b. Press Winkey, right click my computer, properties then click Device Manager.

c. Press Winkey + R then type devmgmt.msc then press enter

5. Turn off Tablet and connect it to PC, Device Manager should look like this if the driver is not installed.

6. Right click Unknown Device, select update driver software and locate the drivers on the Rockchip Folder we extracted. Make sure you browse the proper driver according to your OS.

Press Ok then press Next. Let it install.

7. Now open RKBatchTool at the Rockchip Batch Tool folder.

This will be displayed:

8. Now reconnect your tablet then turn it to flash mode by holding volume up + power button. Connected Devices 1 will turn green.

9. Click the browse button on the upper left (...) select the Firmware / Rom img file you downloaded then click open.

10. Click upgrade then wait until flashing is finished.

Warning: Do not turn off your computer or disconnect the cable while it is flashing!

When tablet automatically boots, flashing is finished. 

You can now use your Tablet!